Hi,
Anyone have experience using dent removal using a stud welder and the Steck stick?
I have had a slap hammer for a long time, but get that nails-down-chalkboard sensation at the thought of drilling holes into metal.
I have seen videos saying to be careful about not burning through the sheetmetal when using the stud welder.
I have used dollies and sheet metal tools too. I gained interest years ago on metal fabrication, from an auto fabricator who used to make cars from a Calendar photo and wood cutouts of curves.
Anyone have experience using dent removal using a stud welder and the Steck stick?
I have had a slap hammer for a long time, but get that nails-down-chalkboard sensation at the thought of drilling holes into metal.
I have seen videos saying to be careful about not burning through the sheetmetal when using the stud welder.
I have used dollies and sheet metal tools too. I gained interest years ago on metal fabrication, from an auto fabricator who used to make cars from a Calendar photo and wood cutouts of curves.