Announcement

Collapse
No announcement yet.

Water Leak...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Water Leak...

    I have a water leak coming in where the black plastic housing for the heater core is. It loves to pool on the floor boards under my rubber flooring. MY question is, do I have to basically go through the procedure of taking the heater core out to seal it, or is there a way to seal the whole thing without going through the trouble?
    -Phil

    sigpic

    +1982 Ford LTD-S Police Car. Built 351w, Trickflow 11R 190 Heads, Holley Sniper EFI, RPM Intake+ Hyperspark dizzy, WR-AOD, Full exhaust headers to tails. 3.27 Trac-Lok Rear. Aluminum Police Driveshaft. Speedway Springs+Bilstein Shocks, Intermediate Brakes, HPP Steering Box.

    +2003 Acura CL Type S 6-speed

    #2
    Take that screen off by the windshield on the passenger side and make sure it's not full of crap down there.
    1990 MGM: $50 E7 heads, HO cam, Holley SysteMAX lower intake, HO upper intake with an Explorer TB. LSC ECM. Lincoln logs into stock dual exhaust. K&N drop in air filter. Wide ratio AOD, 2400 converter with a 3.08 one tire fire out back. Car is less slow now. Then there's the '92 Beater. Dual 2.25" exhaust with shiny tips. Rumbles nice. Super slow. Burns oil too.

    Comment


      #3
      This is likely due to the heater core being replaced at some point. Best thing to do is, remove the vent screen by the windshield then, seal it up with some good sealer/caulking. It should be good then. Just be carefull when washing your car that, you dont point the water directly into the screen.

      1981 Mercury Marquis Brougham 2-Door 302/ 5-speed -special blend (GMGT)
      1987 Lincoln Mark VII 5-speed (Errand runner)
      1989 Mercury Grand Marquis (Base Runner)
      2007 Lincoln Town Car Signature Limited (Hustlyn)
      2011 Ford Crown Victoria Police Interceptor (Down with O.P.P)

      Comment


        #4
        Only place it could be coming through is the air intake vent by the windshield, or maybe if water is running down the firewall, it might be coming in around the bolts that hold the heater core box in place. The bottom of that air intake box is supposed to have a drain in it, and its usually packed full of crud. Check that first.
        86 Lincoln Town Car (Galactica).
        5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

        91 Lincoln Mark VII LSC grandpa spec white and cranberry

        1984 Lincoln Continental TurboDiesel - rolls coal

        Originally posted by phayzer5
        I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

        Comment


          #5
          Thanks guys, I put a tarp over the windshield area of the car during this massive rainstorm, I'm tired of ripping the floor up to dry it out. I'll check all those places. The heater core is original (amazingly, and the cooling system is pristine). I really want to nip this in the bud. I also have a small leak coming from around the windshield, but I intend to take the trim off and seal it with some black silicone.
          -Phil

          sigpic

          +1982 Ford LTD-S Police Car. Built 351w, Trickflow 11R 190 Heads, Holley Sniper EFI, RPM Intake+ Hyperspark dizzy, WR-AOD, Full exhaust headers to tails. 3.27 Trac-Lok Rear. Aluminum Police Driveshaft. Speedway Springs+Bilstein Shocks, Intermediate Brakes, HPP Steering Box.

          +2003 Acura CL Type S 6-speed

          Comment


            #6
            yeah dont let that go too far. If you've not seen pictures of the roof on my car, dig them up and then you'll be more motivated to fix your leaks.
            86 Lincoln Town Car (Galactica).
            5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

            91 Lincoln Mark VII LSC grandpa spec white and cranberry

            1984 Lincoln Continental TurboDiesel - rolls coal

            Originally posted by phayzer5
            I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

            Comment


              #7
              Found 2 leaking grommets, one coming in from the door into the lower a pillar area, and the other in the firewall leaking water. Also there is a smaller slower leaking coming in the heater box. (see Pic) I'm going to try to get to the nut on the other side and tight it, as well as apply black RTV to the grommets, and the bottom of that intake screen
              Click image for larger version

Name:	0405141227.jpg
Views:	1
Size:	63.0 KB
ID:	1274036
              Last edited by Brown_Muscle; 04-05-2014, 09:08 PM.
              -Phil

              sigpic

              +1982 Ford LTD-S Police Car. Built 351w, Trickflow 11R 190 Heads, Holley Sniper EFI, RPM Intake+ Hyperspark dizzy, WR-AOD, Full exhaust headers to tails. 3.27 Trac-Lok Rear. Aluminum Police Driveshaft. Speedway Springs+Bilstein Shocks, Intermediate Brakes, HPP Steering Box.

              +2003 Acura CL Type S 6-speed

              Comment


                #8
                if you have water coming into the heater box like that, I'd have to believe the drain isn't draining.
                86 Lincoln Town Car (Galactica).
                5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

                91 Lincoln Mark VII LSC grandpa spec white and cranberry

                1984 Lincoln Continental TurboDiesel - rolls coal

                Originally posted by phayzer5
                I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

                Comment


                  #9
                  It is, quite well. I ran a hose directly down in there and felt around with my hand to make sure. It was a very large volume of water in short time haha
                  -Phil

                  sigpic

                  +1982 Ford LTD-S Police Car. Built 351w, Trickflow 11R 190 Heads, Holley Sniper EFI, RPM Intake+ Hyperspark dizzy, WR-AOD, Full exhaust headers to tails. 3.27 Trac-Lok Rear. Aluminum Police Driveshaft. Speedway Springs+Bilstein Shocks, Intermediate Brakes, HPP Steering Box.

                  +2003 Acura CL Type S 6-speed

                  Comment


                    #10
                    Well it's raining today, no water on my floor! WOO!
                    -Phil

                    sigpic

                    +1982 Ford LTD-S Police Car. Built 351w, Trickflow 11R 190 Heads, Holley Sniper EFI, RPM Intake+ Hyperspark dizzy, WR-AOD, Full exhaust headers to tails. 3.27 Trac-Lok Rear. Aluminum Police Driveshaft. Speedway Springs+Bilstein Shocks, Intermediate Brakes, HPP Steering Box.

                    +2003 Acura CL Type S 6-speed

                    Comment


                      #11
                      w00t!

                      Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
                      rides: 93 Crown Vic LX (The Red Velvet Cake), 2000 Crown Vic base model (Sandy), 2003 Expedition (the vacation beast)

                      Originally posted by gadget73
                      ... and it should all work like magic and unicorns and stuff.

                      Originally posted by dmccaig
                      Overhead, some poor bastards are flying in airplanes.

                      Comment

                      Working...
                      X