we have been making a set of fender flares for my brothers thunder bird. They are 1" flares they are made of all steel.
 |
-
http://secondhandracing.com/Home.aspx
http://secondhandradio.com/
R.I.P. Jason P Harrill 6-12-06
http://www.grandmarq.net/vb/showthread.php?t=5634 -
Holy crap! Did you bead weld that whole seem? Most times I've ever seen sheet metal welds it's spot welded every 2-3 inches or so, because the metal warps.
-
i welded it all the way but only about 1/4"-1/2" at a time.Originally posted by Blaze86Vichttp://secondhandracing.com/Home.aspx
http://secondhandradio.com/
R.I.P. Jason P Harrill 6-12-06
http://www.grandmarq.net/vb/showthread.php?t=5634Comment
-
It looks nice man, I know that took some time.Comment
-
,aking them only took about 2 hours, getting it preped for paint will take a few more.
BTW this was done with tin snips, a cut off wheel, a hammer and a harbor freight welder.http://secondhandracing.com/Home.aspx
http://secondhandradio.com/
R.I.P. Jason P Harrill 6-12-06
http://www.grandmarq.net/vb/showthread.php?t=5634Comment
-
sweet!!1983 Grand Marquis 2Dr Sedan "Mercules"
Tremec TKO conversion, hydraulic clutch, HURST equipped!
Comment
-
Looks good,Builder/Owner of Badass Panther Wagons
Busy maintaining a fleet of FordsComment
Comment