Installing a new front window??? - - -

[Jill]

cane someone give me a step by step on how to put in a new window in a CV?

passenger front.

know how to take the door panel off really. not sure how to put new glass in.

[85crownHPP]

If the glass is already broken, it wont be too terribly hard.
You'll have to drill out the rivets holding the regulator to the bits of glass left, get those pieces out and clean out the glass from the bottom of the door.
You will need to lower the window regulator using the window switch to get the rivets to a level where you can drill them.
Then just slide the new glass in, and rivet the new glass in. Loosening up the window guide will make getting the new glass in place easier.
You will need big rivets and a big rivet gun - or you can use nuts and bolts, but don't over tighten, or you'll have to do it all over again
Use some nylon washers so you can feel them tighten up before the glass breaks, and you can use self-locking 'ny-lock' nuts so they wont back off, but using a locking nut will make it harder to feel when it starts to tighten up since a self locking nut puts up resistance the whole way.

[Jill]

window switch?

you mean the electric one in the door?
yeah that doesn't work either.

?

[85crownHPP]

Is the switch bad, or the window motor? if the switch is bad, rob a switch from another door to use. If the motor is bad, you have to remove it to move the regulator.
If someone has replaced the motor once before, you will find 3 handy holes drilled revealing the bolts holding the motor in. If not, you will have to drill out the 3 dimples in the door panel found right in front of the bolts holding in the motor to remove it.