On my 91 GM since I got it running again it hesitates when putting it in gear, the fluid is a little on the brown side and when I put a new radiator in it, it got started and puked some out of the lines, could it be as simple as driving it a bit to burp the air out? The most I’ve driven it since I did all the work is putting it on a trailer to go to the exhaust shop, I also replaced the bushing on the throttle side of the TV cable
![]() |
Announcement
Collapse
No announcement yet.
Aod engaging weird
Collapse
X
-
sounds more like low fluid level honestly. The cooler will burp itself almost immediately from flow but you will need to top up whatever was lost from the radiator swap.86 Lincoln Town Car (Galactica).
5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley
91 Lincoln Mark VII LSC grandpa spec white and cranberry
1984 Lincoln Continental TurboDiesel - rolls coal
Originally posted by phayzer5
I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers
-
Originally posted by gadget73 View Postsounds more like low fluid level honestly. The cooler will burp itself almost immediately from flow but you will need to top up whatever was lost from the radiator swap.What I Own: 1993 Mercury Grand Marquis GS
What I Help Maintain: 1996 CV / 1988 CV / 1988 Tempo
Comment
-
Just changing the radiator I'd guess maybe a half quart, but transmissions are prone to leaking anyway so it might have been low to start with. More than about a quart or so and I've found the AOD is slow about engagement.86 Lincoln Town Car (Galactica).
5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley
91 Lincoln Mark VII LSC grandpa spec white and cranberry
1984 Lincoln Continental TurboDiesel - rolls coal
Originally posted by phayzer5
I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers
Comment
-
One run through the gears should have removed all air unless there's a valve body gasket issue causing leaks. That said, the stock tune is very soft shifting anyhow, so if it takes more than one second to engage, you may have internal leaks or low fluid level. AODs are also known for an issue called morning sickness where the pump internal seals will leak out and fail to engage until enough heat is created to have the seals and/or pump case expand those few thousandths to fill in the gap and start pumping correctly.
Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
rides: 93 Crown Vic LX (The Red Velvet Cake), 2000 Crown Vic base model (Sandy), 2003 Expedition (the vacation beast)
Originally posted by gadget73
... and it should all work like magic and unicorns and stuff.
Originally posted by dmccaig
Overhead, some poor bastards are flying in airplanes.
Comment
-
Originally posted by sly View PostOne run through the gears should have removed all air unless there's a valve body gasket issue causing leaks. That said, the stock tune is very soft shifting anyhow, so if it takes more than one second to engage, you may have internal leaks or low fluid level. AODs are also known for an issue called morning sickness where the pump internal seals will leak out and fail to engage until enough heat is created to have the seals and/or pump case expand those few thousandths to fill in the gap and start pumping correctly.
Since I’ve got it running again I haven’t driven it anymore than just pulling it on a trailer to go get tagged and title transferred, it’s just been hesitating when you initially put it into gear
Comment
-
If the initial hesitation is more than 2 seconds, there may be an issue. If it's less than 2 seconds... it's probably fine. If it has a shift kit installed, this should probably be less than 1 second.
Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
rides: 93 Crown Vic LX (The Red Velvet Cake), 2000 Crown Vic base model (Sandy), 2003 Expedition (the vacation beast)
Originally posted by gadget73
... and it should all work like magic and unicorns and stuff.
Originally posted by dmccaig
Overhead, some poor bastards are flying in airplanes.
Comment
-
Originally posted by friskyfrankie View PostSounds good! Just keep an eye on the level and condition of the fluid and you may be fine!
im hoping that’s all it is, it seems like it has to search for 2nd for a bit when shifting up from 1st and I’m hoping it’s just a matter of running it through the gears and needing to top off fluid again. Other than that it shifts smoothly between the rest of the gears
Comment
-
That should be all it is. The upshift being slow may be an indicator of a plunger in the valve body sticking a bit. Driving more may help that, but if it doesn't, as long as it doesn't get worse, it should be fine.
Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
rides: 93 Crown Vic LX (The Red Velvet Cake), 2000 Crown Vic base model (Sandy), 2003 Expedition (the vacation beast)
Originally posted by gadget73
... and it should all work like magic and unicorns and stuff.
Originally posted by dmccaig
Overhead, some poor bastards are flying in airplanes.
Comment
Comment