Motor Mount to Motor Bolts

[TecNickal]

Shame on me for not bagging/tagging the fasteners when disassembling the 89 engine block and the 96 expo engine block.

I figured out the bolts for the bell housing, but I cannot figure out what the bolt looks like that goes from the motor mount and attaches it to the bosses on the engine block. There's a total of 4 bolts. Does anyone have a picture of the head of the bolt/fastener?

[VicCrownVic]

Short and fat shouldered bolts, iirc. I want to say 15mm heads, but could be wrong.

[packman]

I'll see if I still have mine. I replaced all but one of mine with allen-head bolts; the stud on the rear of the engine mount was reused for the transmission brace.

[Mustang Eddie]

The factory bolts are about 3/4" long with a 5/8 head SAE not metric Iirc they are 7/16 course thread will try to dig one up tomorrow for pic.

[TecNickal]

kBoth Mustang Eddie and Vic nailed it. Forgot to say through process of elimination in the daylight I figured out which ones were for what. All done!