what can I do to my existing trans or what trans fits a Town Car that is more performance oriented. I can stay in first gear all the way to 53 miles an hour in my current trans o_O. Would closer gears help?
 |
-
1989 Lincoln Town Car - "Anabelle" - Original block, .030 over with SpeedPro pistons, rods fitted with ARP hardware, FRPP +volume oil pump, GT-40 3bar heads, Crane 1.72 rockers, 89' Fox cam, 93' Cobra lower intake, Explorer upper and 65mm TB, 93' Lightning EGR spacer, K&N intake kit from a 4.0L Ranger, 19lb/hr injectors w/ 87 Mark VII ECM, cat/smog deletes, Big Brake conversion, 3.55 K-Code Trac-Lok/Disc brake rear axle, CVPI LCA's w/1" sway bar in rear, wagon front sway bar, BBK 2.5" off-road H-Pipe, Flowmaster super 40s, HPP wheels, 3G alternator w/LMR.com wiring kit, gear reduction starter conversion, Best 1/4 time: 16.0 @ 85mph. -
A wide ratio kit for the stock AOD is probably the best trans upgrade and it will make the most difference with a stock rear. I think B&M still carries one for around $500 or less, but I'm not sure if Ford Racing still does.Current rides - 1991 Ford Thunderbird 3.8 v6 (gas saver/DD) - New Heads/Headgaskets with ARP studs, Air Silencer Delete, 70mm MAF, Plasti-dipped Matte Black with a Silver Metalflake Overlay, Muffler Delete, some LED's, 30.233 MPG for high MPG average!
2006 Jeep Wrangler 4WD (fun vehicle/backup DD) - 4.0/6spd - too many mods to list.
Associated Panthers:
Father's 1994 Ford Crown Victoria - Stock, 45,000 miles.
Sold in 2007 - 1987 Mercury Grand Marquis LS "Grandpa Special" 2 door.
http://www.cardomain.com/ride/2128327 -
Have you at least put a shift kit in it? Those are always helpful. And staying in 1st gear up to 53 mph seems a little excessive. I have 2.73s and I can only make about 46-47 mph in 1st under WOT.
2001 Ford Crown Victoria P71 - "The Fire Engine"
1985 Lincoln Town Car Signature Series
But God demonstrates his own love for us in this: While we were still sinners, Christ died for us. Romans 5:8Comment
-
Rear gears man. Then a wide ratio kit. And a stall converter. (see my 16 sec lopo post)Builder/Owner of Badass Panther Wagons
Busy maintaining a fleet of FordsComment
-
rear gears and a shift kit first......i know your tranny has low miles so it should be fine
1986 lincoln towncar signature series. 5.0 HO with thumper performance ported e7 heads, 1.7 roller rockers, warm air intake, 65mm throttle body, 1/2" intake spacer, ported intakes, 3.73 rear with trac lock, 98-02 front brake conversion, 92-97 rear disc conversion, 1" rear swaybar, 1 3/16" front swaybar, 16" wheels and tires, loud ass stereo system, badass cb, best time to date 15.94 at 87 mph. lots of mods in the works 221.8 rwhp 278 rwt
2006 Lincoln Town Car Signature. Stock for now
1989 Ford F-250 4x4 much much more to come, sefi converted so far.
1986 Toyota pickup with LSC wheels and 225/60/16 tires.
2008 Hyundai Elantra future Revcon toad
1987 TriBurner and 1986 Alaska stokers keeping me warm. (and some pesky oil heat)
please be patient, rebuilding an empire!
Comment
-
That was today, I had it in 1st gear and didn't shift out till about 5300 rpm. I've done that like once btw just to see.
yep only 72K easy miles. I think I can put in a shift kit myself, but I don't know about the rear gears. If I have to take the axels out to put in 3.73 gears, I might as well do the rear disc conversion while im in there
1989 Lincoln Town Car - "Anabelle" - Original block, .030 over with SpeedPro pistons, rods fitted with ARP hardware, FRPP +volume oil pump, GT-40 3bar heads, Crane 1.72 rockers, 89' Fox cam, 93' Cobra lower intake, Explorer upper and 65mm TB, 93' Lightning EGR spacer, K&N intake kit from a 4.0L Ranger, 19lb/hr injectors w/ 87 Mark VII ECM, cat/smog deletes, Big Brake conversion, 3.55 K-Code Trac-Lok/Disc brake rear axle, CVPI LCA's w/1" sway bar in rear, wagon front sway bar, BBK 2.5" off-road H-Pipe, Flowmaster super 40s, HPP wheels, 3G alternator w/LMR.com wiring kit, gear reduction starter conversion, Best 1/4 time: 16.0 @ 85mph.Comment
-
yup, good idea.Builder/Owner of Badass Panther Wagons
Busy maintaining a fleet of FordsComment
-
5300 rpm in first? That doesn't sound right. Change out the governer to a high speed one while you're doing the shift kit, and make sure your TV pressure is set correctly. It should not go beyond about 4500 with the stock governer unless you were holding it in manual 1, in which case it'll just wind till the motor blows.86 Lincoln Town Car (Galactica).
5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley
91 Lincoln Mark VII LSC grandpa spec white and cranberry
1984 Lincoln Continental TurboDiesel - rolls coal
Originally posted by phayzer5
I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousersComment
-
I was holding it in manual 1 when it went up to 5300 rpm. I shifted it to D at 4500 but the linkage isn't that acurrate so it didn't quite engage 2nd gear till I tapped it again. I hate revving this thing up like that, it seems like after I do that it smells of burnt oil and the exhaust leaks near the headers get worse.1989 Lincoln Town Car - "Anabelle" - Original block, .030 over with SpeedPro pistons, rods fitted with ARP hardware, FRPP +volume oil pump, GT-40 3bar heads, Crane 1.72 rockers, 89' Fox cam, 93' Cobra lower intake, Explorer upper and 65mm TB, 93' Lightning EGR spacer, K&N intake kit from a 4.0L Ranger, 19lb/hr injectors w/ 87 Mark VII ECM, cat/smog deletes, Big Brake conversion, 3.55 K-Code Trac-Lok/Disc brake rear axle, CVPI LCA's w/1" sway bar in rear, wagon front sway bar, BBK 2.5" off-road H-Pipe, Flowmaster super 40s, HPP wheels, 3G alternator w/LMR.com wiring kit, gear reduction starter conversion, Best 1/4 time: 16.0 @ 85mph.Comment
-
gears, shift kit. Trans Go HP shift kit, its easy, takes a few hours and it makes the tranny a whole different animal.
2009 Ford F-350 6.4 powerstroke diesel. 1977 Ford F-150 built 300 six, 5 speed trans. 1976 MG MGB roadster, 359w, t5 5 speed. 1996 Kawasaki ninja ZX6R.
My rod is glowing, my bead is clean, my middle name is acetyleneComment
-
So you do it...why?Originally posted by 89LincolnTWNcar
2001 Ford Crown Victoria P71 - "The Fire Engine"
1985 Lincoln Town Car Signature Series
But God demonstrates his own love for us in this: While we were still sinners, Christ died for us. Romans 5:8Comment
-
racing an 83' nissan Z :evil:1989 Lincoln Town Car - "Anabelle" - Original block, .030 over with SpeedPro pistons, rods fitted with ARP hardware, FRPP +volume oil pump, GT-40 3bar heads, Crane 1.72 rockers, 89' Fox cam, 93' Cobra lower intake, Explorer upper and 65mm TB, 93' Lightning EGR spacer, K&N intake kit from a 4.0L Ranger, 19lb/hr injectors w/ 87 Mark VII ECM, cat/smog deletes, Big Brake conversion, 3.55 K-Code Trac-Lok/Disc brake rear axle, CVPI LCA's w/1" sway bar in rear, wagon front sway bar, BBK 2.5" off-road H-Pipe, Flowmaster super 40s, HPP wheels, 3G alternator w/LMR.com wiring kit, gear reduction starter conversion, Best 1/4 time: 16.0 @ 85mph.Comment
Comment