Need 1990 Crown Vic rear quarter panel

[Lazerbeans]

I have a 1990 Crown Vic sedan, which I need the driver’s side rear quarter panel for. I have looked around in Kansas and every junkyard says they have crushed their older cars. So if anyone has one they would sell me, or know of a source for one I would appreciate it. I basically need from the door back to the bumper and from around top or better of the gas door. Minor damage ok.
Thanks

[LTDMan83]

I can get you a good rear quarter, if your willing to pay for the total cost involved, which won't be cheap. I just recently did this for a guy on one of the other forums I am on, and it was around $350 total. I will have to build a full-size crate to ship it in for protection though, which runs up the cost. Last time the crate was $50 to build, and ended up costing around $160 to ship. + the cost of the quarter $40, and my finders/time fee.

Would be cheaper to find your own QP of course, but I'm willing to help you out for a cost, if you really need it. I can go cut one off a nice Box CV for you right now, but it will take me a little while to get it shipped out to you, as I'm very busy this time of year. Lmk.

[84GrandMarquis]

http://www.autobidmaster.com/carfinder-online-auto-auctions/lot/25125080/COPART_1988_FORD_CROWN_VICT_SALVAGE_CERTIFICATE_OF_TITLE_KANSAS_CITY_KS/

I've never purchased a car from these guys, but buying an entire car like this one might be your best bet. Be careful though, they charge a couple hundred dollars in fees. So a 350 dollar bid might end up costing closer to 550.

[84GrandMarquis]

Or better yet http://wichita.craigslist.org/cto/2111055551.html

[Lazerbeans]

Thanks guys. All the salvages in my area have crushed all the older cars, so I am having trouble finding one. I had forgotten about craigs list.

[87gtVIC]

Travel out of state and try your luck getting it with your bare hands. I searched a couple years for pieces I needed and nothing was local. No room near me for pull it yards so I had no choice.